Place your template on the front of the dartboard and adjust the position of the marker if necessary. In any case, please check if the cross on your template matches the actual position of the Bulls Eye. Some dartboards are not quite up to standard. This results in the middle of a point that marks the Bulls a dartboard. Now take the sheet of paper from the dart board and place it on the floor or a table to connect the marked points diagonally with a line. Then place the blank sheet of paper on the dartboard and mark all the holes on the paper so that they are still visible later. Take a look at where the four drill holes are located approximately at the outer edges. Place your dartboard with the number segments down on the floor. If you do not have this at hand, you can also glue 2 smaller A4 sheets together with some adhesive tape. The following items are required for making the template:įor the creation of the stencil, a large sheet of paper in A3 format is suitable. If such a template is not included, you can make it yourself with simple means to simplify the installation of the dartboard. Some of the dartboards already come with a pre-made template that allows them to transfer the markings for the holes to the wall. Therefore, the bullseye as the central, fixed point of a dartboard is always the reference point. Round or square shapes make it difficult to uniformly hold the dartboard. One end is fastened in the bullseye, the other end marks the ejection line.Īnother reason why the bullseye is the key measurement point are the different designs of dartboards. You can buy this from specialist retailers, you can also make it yourself. If you find it difficult to measure the diagonal, you can use a distance measure. This is one reason why bullseye is always measured. However, the diagonal is decisive in the competition order. However, in the case of uneven surfaces and whales, deviations from the standard distance measure are often found on the diagonal At first glance, it may seem easier to gauge the height of the dartboard and the distance to the oche, to the ejection line. If you look at our graphics with the different dimensions, you can quickly see that all measurements and dimensions start or end at the bullseye. & nbsp The Measures for Soft Dart at a Glance Distance from the wall to the discharge line: 237 cmĪttention: The dimensions for attaching the dartboard to the E-Dart are different from those for the Steel Dart.Diagonal distance from the Bulls Eye to the Off the line (Oche): 293 cm. From the floor to the bulls eye of the dartboard: 173 cm.On the sketch above you can see very well that the distance from the throw line to the dartboard is a little lower than the one above The Steel Dart Board hangs one centimeter higher than the Electronic Soft Dart Board. OFFICIAL MAE AND DISTANCE ON THE STEEL DART
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |